One car bay: ULTRABEAM Nested Box 3-Box 2.4 m on the ceiling of a 3 x 6 m single garage

Box garage lights that plug into a power point.

Your garage, properly lit.

What are you lighting?

Lights one car and the floor around it.

24 tubes, 2.4 x 2.4 m. Nested Box 3-Box 2.4 m

$649 ~~$799~~

See this kit or design your own

In stock in Melbourne

Kits and every spare part, with free shipping Australia-wide.
Safety certified

To Australian standards, on an earthed 3-pin plug.
Free shipping

Australia-wide, with 40-day easy returns.
5-year warranty

On the LEDs and every electrical part.

Pick by room

Box light kits for your garage

One car bay

Up to 2.5 m long, over one car.

ULTRABEAM Nested Box 3-Box 2.4 m, 2.4 x 2.4 m

2.4 x 2.4 m $649 3-Box 2.4 m

Single garage

Down a single garage.

See all 6 sizes

ULTRABEAM Nested Box 3-Box 2.9 m, 2.9 x 2.4 m

2.9 x 2.4 m $659 3-Box 2.9 m

ULTRABEAM Nested Box 3-Box 4.1 m, 4.1 x 2.4 m

4.1 x 2.4 m $789 3-Box 4.1 m

ULTRABEAM Nested Box 3-Box 4.8 m, 4.8 x 2.4 m

4.8 x 2.4 m $849 3-Box 4.8 m

ULTRABEAM Nested Box 3-Box 5.8 m, 5.8 x 2.4 m

5.8 x 2.4 m $869 3-Box 5.8 m

All 7 sizes

Find the box light kit that fits your ceiling

Every box size, sorted by room and length. Sizes read length by width.

Up to 2.5 m long, over one car.

2.4 x 2.4 m 24 tubes 3-Box 2.4 m $649

Certified for Australia. Look up our registration
5-year warranty on the LEDs and every electrical part.
In stock in Melbourne, with free shipping Australia-wide.
Plugs into a power point. Spare parts on hand.

Garage lighting

A light kit for every size of garage.

Workshop lighting

See the job, not your own shadow.

Gym lighting

Light the whole training floor.

Before you order

Pick your room at the top of this page. The kit that fits is shown on its ceiling, to scale, with its length and width.

The box frames the bay, so light falls on both sides and both ends of the car, with no hard shadows along the doors. Each size's lumens are on its page.

Lay it out on the floor, click the tubes into the connectors and test it. Then lift it and fix it to the ceiling. An afternoon with a helper. See the install guide.

Not to plug them in. Each box has its own 1.5 m cord and plug, all at one corner, so a 2-Box takes two power points and a 3-Box takes three. To put them on a wall switch, use a licensed electrician.

The tubes, the corner and joiner connectors, hanging cables, fixings and a power cord for each box. Every kit ships complete. Spare tubes, connectors and cords are on the shelf too.

Yes. Every tube, connector and cord is stocked on its own, so you can extend the layout or change the shape whenever you like.

Yes. ULTRABEAM is RCM marked and EMC tested against AS/NZS standards, and ships with an earthed 3-pin AU plug.

Flush to the ceiling, or dropped on the included suspension cables for higher ceilings. It works on plasterboard, concrete, timber and steel.

They use about 60% less power than the fluoros they replace. The LEDs are rated to 50,000 hours. Every tube has its own driver, so one fault does not take out the kit.

Sizing and install guide

Size and hang box garage lights yourself

What to measure, how bright to go and how the kit goes up. Tap a question to open it.

It comes down to the room. A 6 x 6 m double garage takes two 3-Box 4.8 m lights, one over each bay. A 3 x 6 m single garage takes one box run lengthways, 2.9 to 5.8 m long. One car bay suits a 2.4 m box.

Work it out from the floor area. General parking needs about 100 to 200 lumens a square metre. A workshop wants 300 to 500, and a detailing bay 500 to 750. A showroom look starts around 750. Each kit's lumens are on its page. A ceiling over 2.7 m or dark walls call for a bigger kit.

Measure the clear ceiling between the walls, the door tracks and the opener rail. Sizes read length by width. A 4.8 x 2.4 m box is 4.8 m long. In a single garage, run it lengthways, the way the car parks. Check a power point sits within reach of each box's 1.5 m cord.

Split the light around it. In a double garage, fit two 3-Box 4.8 m lights, one each side of the motor. In a single garage, a 3-Box 2.9 m sits behind the motor. Over one bay, a 3-Box 2.4 m fits behind it. The door motor switch at the top of this page shows each one on the ceiling.

Clear a patch of floor the size of the kit and lay out the parts.
Click each tube into its connector until you feel it seat.
Plug it in and check every tube lights up.
Mark the ceiling, lift the kit with a helper and screw through the connector holes, not the tubes. On plasterboard, use wall plugs or toggle bolts.
Run the cord along the ceiling to the power point with cable clips, and switch on.

You need a drill, a step ladder, a tape measure and a pencil.

A batten puts one line of light on the ceiling. A box frames the bay in 8 to 44 tubes, so light falls on both sides and both ends of the car. You get even light, with no hard shadows along the doors.

Daylight white. Every ULTRABEAM kit is 6500K, the colour of the midday sun. Warm white around 3000K suits a lounge, and it softens every colour. At 6500K and CRI 85+, you see your paint as it really is. Wire colours and wood grain read clearly too.